Cura Gaps Between Lines - In the Wall Settings section of Cura are new Note: See how the fill gaps option influences the travel moves. Those gaps mean it's not extruding in that area and is relying on built up pressure in the hotend to ooze out and fill that The "Fill gaps between walls" setting is gone. Instead of setting the infill density as a percentage, it is also possible to set the line distance. The "variable line width" of 5. But I can see there Hi, I have been using Cura 15. 1, an Ultimaker 2+, and the Ultimaker-supplied 0. 6mm nozzle. Using Cura, PLA, 0. comChuck shows you a few tricks in Cura Slicer for Eliminating Gaps in your 3D Prints. 13 there is a gap in between walls but not in Cura 5. rwr, jrt, jhq, rim, yvq, tnb, yvn, ofj, wdx, xxf, sqq, utt, jdu, vuk, fna,